62A Series Channel Balances

Ordering Information
1. Measure channel length (do not include any attached ends).
2. Check number stamped on channel. (e.g., 2210, 22DS, etc.)
3. Select our corresponding part number from the chart below.
4. If the number stamped on the balance ends with DS (double spring), you will need to select the exact weight from the weight range in the chart. An example would be if the number stamped on your balance is 19DS, you’ll need to select the exact weight of the sash between 30-40 lbs. (ex. 32lbs). Then add the weight to the part number from the chart below. Ex: 62-19DS32
5. Balances that are 29" & above that have 90 stamped on the balance (ex. 3090) are no longer available. These balances are being substituted with the 50 weight range balances (ex. 3050). Balances that are below 29" & have 90 stamped on the balance (ex. 2590) they will need to be ordered by replacing the 90 that is stamped on the balance with the letter "S" (ex. 2590 to 25S). Then you will need the exact weight of the sash (usually stamped on balance. If not, you’ll need to weigh the sash) & add the weight after the letter "S" (ex: if the sash weighs 28lbs, the part number would be 62-25S28). 6. Some balances maybe stamped with the letter "U" or "L" that indicates Upper sash or Lower sash. If your balance is stamped with the letter U or L, please add the letter to the end of the part number (ex. 62-305L or 62-25S28U).
7. Identify the appropriate end bracket to be attached from the illustrations shown; then add -1,-2,-3, etc suffix to complete our part number.